High-temperature and high-pressure accelerated aging test chamber HAST Rongjida

I. Product Application: The HAST high-pressure accelerated aging test chamber is a specialized test chamber mainly used to simulate the performance and operational reliability of materials under high-temperature, high-pressure, and high-humidity environments. The inner chamber of the aging chamber adopts an arc design, which complies with national safety container standards. It is suitable for industries such as defense materials, aerospace materials, electronic components, semiconductors, and circuit boards. Ii. Execution Standards: GB/T2423.40-1997 Environmental testing for electrical and electronic products - Part 2: Test Method Cx: Constant damp heat of unsaturated high-pressure steam Iec 60068-2-66-1994 Environmental Testing. Part 2-66: Test Methods. Test Cx: Steady-state wet heat The temperature and humidity offset life of the JESD22-A100 cycle JESD22-A101 Steady-state Temperature, Humidity/bias, Life Test (Temperature, Humidity, Bias Life) JESD22-A102 High-Pressure cooking Test (Accelerated Resistance to Moisture penetration) JESD22-A108 Temperature, bias Voltage and working life JESD22-A110 HAST high acceleration temperature and humidity stress test JESD22-A118 Temperature and Humidity High Acceleration Stress Test without bias voltage UHAST (Unsaturated high-pressure steam without bias voltage) Iii. Main Parameters The dimensions inside the box (mm) are Φ350×480, φ400×550, Φ500×650, Φ800×1000 Overall dimensions (mm) : 720×920×1600, 700x1000x1710, 850x1150x1760, 1100x1750x1960 Temperature range: 100℃ to 145℃ (saturated vapor temperature) The temperature fluctuation is ±0.5℃ The temperature uniformity is 2℃ Humidity range: 80%R.H to 100%R.H Humidity fluctuation ±1.5%R.H The humidity uniformity is 3.0%R.H Pressure range: 0.2 to 3kg/cm² (0.05 to 0.294MPa) The heating time from room temperature to 145°C is approximately 40 minutes The controller features a 7-inch color touch screen and an intelligent fuzzy controller operating system The inner box material is SUS304 stainless steel plate: The inner liner is fully welded as a whole The outer box is made of high-quality anti-corrosion electrolytic plates with a surface electrostatic powder coating The insulation layer is a super-fine glass wool insulation layer with a flame retardant grade of A1 Noise ≤60 decibels (dB) (Measured 1 meter away from the equipment door with the noise detection device) Iv. Product Features Outer box material: High-quality anti-corrosion electrolytic plate, surface electrostatic powder baking paint, color reaching the standard color of Rongji Inner box material: SUS304 stainless steel plate: The inner liner is fully welded as a whole Insulation layer: Superfine glass wool insulation layer, flame retardant grade A1 Controller: 7-inch color touch screen intelligent fuzzy controller operating system Noise: ≤60 decibels (dB) (Measured 1 meter away from the equipment door with the noise detection device) The circular stainless steel inner box structure can prevent condensation and dripping during the test, meeting the standards for industrial safety containers. Pressure-regulating door lock with good sealing performance. Precise structural design, low water consumption, and each water addition can last for 200 hours continuously. The design of the safety door makes it impossible to conduct tests without closing it. Overpressure protection: Automatic exhaust and pressure relief in case of overpressure. Over-temperature protection: When the temperature is too high, the indicator light will sound an alarm and the test will be stopped.